Flexisign pro 10 printer status return error
![flexisign pro 10 printer status return error flexisign pro 10 printer status return error](https://cdn2.iconfinder.com/data/icons/cloud-computing-110/492/4298_-_Virus-256.png)
M280 P0 S60 puts it into the M119 test mode.M280 P0 S90 should stow the probe and the orange LED will be ON.M280 P0 S10 should deploy the probe and the orange LED will be OFF.If enabled then check wiring and check that the correct pin is being used.
![flexisign pro 10 printer status return error flexisign pro 10 printer status return error](https://m.media-amazon.com/images/I/918CeMHcvHL._AC_SX466_.jpg)
If not check that the BLTouch is enabled in the configuration. Blue LED will be ON if a servo signal is present.I found some troubleshooting suggestions here and this are the results of my testing:
#Flexisign pro 10 printer status return error serial
I'm able to restart the serial connection and run Gcode commands. Set it after restarting)Ĭhanging monitoring state from 'Error: STOP called because of BLTouch error - restart with M999 Recv: Error:Printer stopped due to errors. Recv: Error:STOP called because of BLTouch error - restart with M999Ĭhanging monitoring state from 'Connecting' to 'Error: STOP called because of BLTouch error - restart with M999 Recv: echo:Acceleration (units/s2): P R T Recv: echo:Maximum Acceleration (units/s2): Recv: echo:V41 stored settings retrieved (498 bytes crc 23991) look at what the Bits Per Second option is set to. in the Control Panell, open System, click the hardware tab, click the Device Manager button, and under Ports find your cutter. Recv: echo: Free Memory: 5215 PlannerBufferBytes: 1232 the bit-rate that the computer transfers information to your cutter has to match in THREE places: 1. Recv: echo: Last Updated: 12:00 | Author: (none, default config)